Tekko32 F4 45A ESC

The ESC is using the BLHELI32 FW (version 32.9)

setting description: https://oscarliang.com/best-blheli-32-settings/#Rampup-Power

Open

https://miniquadtestbench.com/
Change PWM to 42kHz this will help the throttle smoothening at higher RPM
Increase timing will give more torque, 23-25deg should work fine.
Desync can be low or high, for high kv motors we can set it to high just to make sure we never miss a zero crossing
Ramp up power can be between 30-50%, basically we limit the change in duty that the fets are allowed to change. This will help limiting the current spikes
Leav current limit off and leave maximum acceleration at maximum, only used for big motors.
Level damped mode off, this means we have active break so the props slows down faster
Auto telemetry will send data to the FC without the FC having to ask for it

BLHeli32

Setup ESC

1. Download BLHeliSuite32 setup tool: Releases · bitdump/BLHeli

2. Use an Arduino (NANO) to communicate with the ESC https://www.youtube.com/watch?v=eFDN0MGWz10&ab_channel=DroneMesh

   1. Use pin D3 and GND and connect to the PWM and GND of the ESC

Open