Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 8 Next »

The flight controller implements a number of critical low-level behaviors.

This document is work in progress - do not follow it literally, yet.

Installing Cleanflight Configurator (CFC)

Connecting to the Flight Controller (FC)

  1. Unplug the battery from your drone

    1. double-check the battery is unplugged

  2. Disconnect the Raspberry Pi from the FC

  3. Connect the mini USB cable to your FC and to your base station

  4. Start CFC on your base station

5. Select the correct connection port in the top right corner

  • Details might vary depending on available connections on your base station, but the correct port should start with: /dev/tty.serial*

6. Leave the baud rate (number) at the default value of 115200

7. Press “Connect”

You should be greeted by a “Setup” page with a rendering of your drone:

Configuring the flight controller

  • No labels