...
The OSD version of FC does not enter Bootloader mode
It is tricky to jump the exposed Boot pins. Try applying a bit of force when pressing on the pins. If possible, also try verifying they have actually been jumped with a multi-meter.
On the Firmware Flasher tab, when clicking Flash Firmware button, the progress bar turns red and shows “No response from the bootloader, programming: FAILED”
This is likely due to the FC not being in Bootloader mode. Please double check the indicators of that mode in the section above.
On the Firmware Flasher tab, when the flashing started and user verified “Flashing…” on the progress bar, eventually the flashing/verification failed with a “Timeout” error.
Click the Flash Firmware button and try again
If the user experiences other issues or the steps above do not resolve the problem, please contact our hardware team via email.
This page can be used to do a quick test of the onboard IMU: move the drone and verify that the rendering of the drone moves. Don’t expect it to be perfect as we still need to calibrate everything.
We will return to this page later while performing calibrations (https://ethidsc.atlassian.net/l/cp/WNont9ZB).
...
You are now connected to the FC and able to configure itYou now have the updated flight controller firmware! Connect to it in Normal mode and we will configure it next.